Please use this identifier to cite or link to this item:
|Title:||Enhanced hollow fiber membrane performance via semi-dynamic layer-by-layer polyelectrolyte inner surface deposition for nanofiltration and forward osmosis applications||Authors:||Liu, Chang
|Keywords:||DRNTU::Engineering::Environmental engineering::Water treatment||Issue Date:||2014||Source:||Liu, C., Shi, L.,& Wang, R. (2014). Enhanced hollow fiber membrane performance via semi-dynamic layer-by-layer polyelectrolyte inner surface deposition for nanofiltration and forward osmosis applications. Reactive and functional polymers.||Series/Report no.:||Reactive and functional polymers||Abstract:||The layer-by-layer (LBL) polyelectrolyte deposited membranes have drawn increasing attention in various applications due to the ease of selective layer formation and their stability and versatility. In this study, the LBL deposition was performed at the inner surface of the polyethersulfone (PES) hollow fiber substrate to form composite nanofiltration (NF) membrane. The semi-dynamic deposition procedure was adopted with the aid of syringes. The newly developed inner deposited (id-LBL) membranes were then tested in NF and forward osmosis (FO) applications and the performance were compared with outer surface deposition as well as some literature data. The id-LBL membranes could not only withstand higher operating pressure but also possess superior hardness rejection especially in high concentration mixed salt solutions (more than 95% rejection to Mg2+ and Ca2+ in a 5000 ppm total dissolved salt (TDS) mixture under 4.8 bar). As for the FO process, with only two layer deposition, the id-LBL membranes also demonstrated significant performance improvement with increased water flux (up to 70 L/m2 h using 0.5 M MgCl2 as draw solution in active layer facing draw solution configuration) and reduced salt leakage (around 0.5 g/m2 h using 1 M MgCl2 draw solution in active layer facing feed water configuration). This study suggests that for hollow fiber substrate, the inner surface is more suitable for the formation of the selective layer via LBL deposition than the outer surface.||URI:||https://hdl.handle.net/10356/79613
|ISSN:||1381-5148||DOI:||10.1016/j.reactfunctpolym.2014.07.018||Rights:||© 2014 Elsevier B. V. This is the author created version of a work that has been peer reviewed and accepted for publication by Reactive and Functional Polymers. It incorporates referee’s comments but changes resulting from the publishing process, such as copyediting, structural formatting, may not be reflected in this document. The published version is available at: [http://dx.doi.org/10.1016/j.reactfunctpolym.2014.07.018].||Fulltext Permission:||open||Fulltext Availability:||With Fulltext|
|Appears in Collections:||CEE Journal Articles|
NEWRI Journal Articles
Items in DR-NTU are protected by copyright, with all rights reserved, unless otherwise indicated.