dc.contributor.authorShaegh, Seyed Ali Mousavi
dc.contributor.authorNguyen, Nam-Trung
dc.contributor.authorChan, Siew Hwa
dc.date.accessioned2012-05-14T02:54:44Z
dc.date.available2012-05-14T02:54:44Z
dc.date.copyright2010en_US
dc.date.issued2010
dc.identifier.citationShaegh, S. A. M., Nguyen, N. T., & Chan, S. H. (2010). An air-breathing microfluidic formic acid fuel cell with a porous planar anode: experimental and numerical investigations. Journal of Micromechanics and Microengineering, 20(10).en_US
dc.identifier.urihttp://hdl.handle.net/10220/7932
dc.description.abstractThis paper reports the fabrication, characterization and numerical simulation of an air-breathing membraneless laminar flow-based fuel cell with carbon-fiber-based paper as an anode. The fuel cell uses 1 M formic acid as the fuel. Parameters from experimental results were used to establish a three-dimensional numerical model with COMSOL Multiphysics. The simulation predicts the mass transport and electrochemical reactions of the tested fuel cell using the same geometry and operating conditions. Simulation results predict that the oxygen concentration over an air-breathing cathode is almost constant for different flow rates of the fuel and electrolyte. In contrast, the growth of a depletion boundary layer of the fuel over the anode can be the major reason for low current density and low fuel utilization. At a low flow rate of 10 µl min−1, simulation results show a severe fuel diffusion to the cathode side, which is the main reason for the degradation of the open-circuit potential from 0.78 V at 500 µl min−1 to 0.58 V at 10 µl min−1 as observed in experiments. Decreasing the total flow rate 50 times from 500 µl min−1 to 10 µl min−1 only reduces the maximum power density approximately two times from 7.9 to 3.9 mW cm−2, while fuel utilization increases from 1.03% to 38.9% indicating a higher fuel utilization at low flow rates. Numerical simulation can be used for further optimization, to find a compromise between power density and fuel utilization.en_US
dc.format.extent21 p.en_US
dc.language.isoenen_US
dc.relation.ispartofseriesJournal of micromechanics and microengineeringen_US
dc.rights© 2010 IOP Publishing Ltd. This is the author created version of a work that has been peer reviewed and accepted for publication by Journal of Micromechanics and Microengineering, IOP Publishing Ltd. It incorporates referee’s comments but changes resulting from the publishing process, such as copyediting, structural formatting, may not be reflected in this document. The published version is available at: [http://dx.doi.org.ezlibproxy1.ntu.edu.sg/10.1088/0960-1317/20/10/105008].en_US
dc.subjectDRNTU::Engineering::Mechanical engineering
dc.titleAn air-breathing microfluidic formic acid fuel cell with a porous planar anode : experimental and numerical investigationsen_US
dc.typeJournal Article
dc.contributor.schoolSchool of Mechanical and Aerospace Engineeringen_US
dc.identifier.doihttp://dx.doi.org.ezlibproxy1.ntu.edu.sg/10.1088/0960-1317/20/10/105008
dc.description.versionAccepted versionen_US
dc.identifier.rims159363


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record