Please use this identifier to cite or link to this item: https://hdl.handle.net/10356/150574
Full metadata record
DC FieldValueLanguage
dc.contributor.authorTheng, Clarence Wen Junen_US
dc.date.accessioned2021-06-01T11:50:48Z-
dc.date.available2021-06-01T11:50:48Z-
dc.date.issued2021-
dc.identifier.citationTheng, C. W. J. (2021). Experimental investigation of 3-D printed bonded scarf joints failure response. Final Year Project (FYP), Nanyang Technological University, Singapore. https://hdl.handle.net/10356/150574en_US
dc.identifier.urihttps://hdl.handle.net/10356/150574-
dc.description.abstractThe use of traditional manufacturing methods for the repair of composite in the aerospace industry has been prevalent. However, as the world revolves and moves towards additive manufacturing, additive manufacturing has been explored for the use of repairs. A frequently used repair technique is adhesive bonding joint repair. In the repair of adhesive bonding joint, commonly used joints include scarf joints, butt joints and lap joints. However, these joints have trade-offs. The repair requires large amount of materials to be removed and thus in return might damage the material further. Butt joint and lap joint does not give a flushed aerodynamic finishing. Extensive research has shown that scarf joint has the best mechanical properties all repairs however it has a large repair signature. Therefore, new novel joints figuration was developed to attempt to reduce the repair signature while having similar or better mechanical properties of a scarf joint. A combination of interlocking joint, scarf joint and step joints were used in the designing process. Four different joint configurations were 3D printed. Namely scarf joint as a control, step joint, stagger joint and stager joint with pins. These joints was printed using Carbon Fiber Reinforced Polymer with Onyx as the polymer. Tensile test was then conducted on these four joints using scarf joint as the benchmark. Strain and load were recorded with a strain gauge and plotted on a graph to be observed. The experimental results of the three novel joints in comparison with a scarf joint showed promising results. The results obtained have shown that the novel mechanical joint designs were stronger than the adherend. However, further research must be done to fulfil the criteria of reducing repair signature while keeping the mechanical properties similar to a scarf joint.en_US
dc.language.isoenen_US
dc.publisherNanyang Technological Universityen_US
dc.relationB213en_US
dc.subjectEngineering::Aeronautical engineeringen_US
dc.subjectEngineering::Mechanical engineeringen_US
dc.titleExperimental investigation of 3-D printed bonded scarf joints failure responseen_US
dc.typeFinal Year Project (FYP)en_US
dc.contributor.supervisorSridhar Idapalapatien_US
dc.contributor.schoolSchool of Mechanical and Aerospace Engineeringen_US
dc.description.degreeBachelor of Engineering (Mechanical Engineering)en_US
dc.contributor.supervisoremailMSridhar@ntu.edu.sgen_US
item.grantfulltextrestricted-
item.fulltextWith Fulltext-
Appears in Collections:MAE Student Reports (FYP/IA/PA/PI)
Files in This Item:
File Description SizeFormat 
ClarenceThengU1822543J FYP Report.pdf
  Restricted Access
5.17 MBAdobe PDFView/Open

Page view(s)

128
Updated on Jun 30, 2022

Download(s)

4
Updated on Jun 30, 2022

Google ScholarTM

Check

Items in DR-NTU are protected by copyright, with all rights reserved, unless otherwise indicated.