Please use this identifier to cite or link to this item: https://hdl.handle.net/10356/157263
Title: Effect of surface defect on specimen and insertion distance of striker bar in tensile split Hopkinson pressure bar test
Authors: Lim, Zhi Hong
Keywords: Engineering::Materials::Mechanical strength of materials
Engineering::Materials::Material testing and characterization
Issue Date: 2022
Publisher: Nanyang Technological University
Source: Lim, Z. H. (2022). Effect of surface defect on specimen and insertion distance of striker bar in tensile split Hopkinson pressure bar test. Final Year Project (FYP), Nanyang Technological University, Singapore. https://hdl.handle.net/10356/157263
Project: B185
Abstract: Available in the materials laboratory of Nanyang Technological University (NTU) Singapore, are three variations of Split Hopkinson Pressure Bar (SHPB). The SHPBs are used to evaluate the mechanical characteristics of materials under high strain rates, at various dynamic loading situations through compression, tension and torsion. The dynamic tension SHPB will be the sole focus for this report. The tensile SHPB is used to assess dynamic stress and strain response under tension at high strain rates ranging from 102 to 104 S-1. Its theory is based on longitudinal stress waves propagating along elastic bars. Strain gauges are installed on the input and output bars, raw data is collected by using an oscilloscope to transfer voltage signal from the strain gauges. Stress vs strain, strain rate vs time, and strain vs time curves are generated after data collection and compared to existing literature articles. The goal of this project is to verify that the SHPB experimental setup at NTU is accurate, reliable, and repeatable. Multiple tests such as empty runs and calibration runs were conducted. The results from each of these tests should preferably differ by less than 5% but a percentage error of less than 10% is acceptable. The results are also compared to past year papers to ensure repeatability. Once calibration is done, the project will investigate the effects of varying insertion distance of the striker bar into the barrel of the gas chamber, on the mechanical properties of sheet metal Al6061-T6 test piece. The velocity of the striker bar will also be measured. In addition, the effects of a surface defect on the mechanical properties of test piece will also be looked into. Conclusion of the project will be included at the end of the report. Problems faced during this project will also be discussed, followed by recommendations to improve on this project.
URI: https://hdl.handle.net/10356/157263
Fulltext Permission: restricted
Fulltext Availability: With Fulltext
Appears in Collections:MAE Student Reports (FYP/IA/PA/PI)

Files in This Item:
File Description SizeFormat 
FYP (B185) Final report 2021-2022.pdf
  Restricted Access
2.84 MBAdobe PDFView/Open

Page view(s)

9
Updated on May 24, 2022

Download(s)

1
Updated on May 24, 2022

Google ScholarTM

Check

Items in DR-NTU are protected by copyright, with all rights reserved, unless otherwise indicated.