Please use this identifier to cite or link to this item: https://hdl.handle.net/10356/157263
Full metadata record
DC FieldValueLanguage
dc.contributor.authorLim, Zhi Hongen_US
dc.date.accessioned2022-05-12T12:58:40Z-
dc.date.available2022-05-12T12:58:40Z-
dc.date.issued2022-
dc.identifier.citationLim, Z. H. (2022). Effect of surface defect on specimen and insertion distance of striker bar in tensile split Hopkinson pressure bar test. Final Year Project (FYP), Nanyang Technological University, Singapore. https://hdl.handle.net/10356/157263en_US
dc.identifier.urihttps://hdl.handle.net/10356/157263-
dc.description.abstractAvailable in the materials laboratory of Nanyang Technological University (NTU) Singapore, are three variations of Split Hopkinson Pressure Bar (SHPB). The SHPBs are used to evaluate the mechanical characteristics of materials under high strain rates, at various dynamic loading situations through compression, tension and torsion. The dynamic tension SHPB will be the sole focus for this report. The tensile SHPB is used to assess dynamic stress and strain response under tension at high strain rates ranging from 102 to 104 S-1. Its theory is based on longitudinal stress waves propagating along elastic bars. Strain gauges are installed on the input and output bars, raw data is collected by using an oscilloscope to transfer voltage signal from the strain gauges. Stress vs strain, strain rate vs time, and strain vs time curves are generated after data collection and compared to existing literature articles. The goal of this project is to verify that the SHPB experimental setup at NTU is accurate, reliable, and repeatable. Multiple tests such as empty runs and calibration runs were conducted. The results from each of these tests should preferably differ by less than 5% but a percentage error of less than 10% is acceptable. The results are also compared to past year papers to ensure repeatability. Once calibration is done, the project will investigate the effects of varying insertion distance of the striker bar into the barrel of the gas chamber, on the mechanical properties of sheet metal Al6061-T6 test piece. The velocity of the striker bar will also be measured. In addition, the effects of a surface defect on the mechanical properties of test piece will also be looked into. Conclusion of the project will be included at the end of the report. Problems faced during this project will also be discussed, followed by recommendations to improve on this project.en_US
dc.language.isoenen_US
dc.publisherNanyang Technological Universityen_US
dc.relationB185en_US
dc.subjectEngineering::Materials::Mechanical strength of materialsen_US
dc.subjectEngineering::Materials::Material testing and characterizationen_US
dc.titleEffect of surface defect on specimen and insertion distance of striker bar in tensile split Hopkinson pressure bar testen_US
dc.typeFinal Year Project (FYP)en_US
dc.contributor.supervisorShu Dong Weien_US
dc.contributor.schoolSchool of Mechanical and Aerospace Engineeringen_US
dc.description.degreeBachelor of Engineering (Mechanical Engineering)en_US
dc.contributor.supervisoremailMDSHU@ntu.edu.sgen_US
item.grantfulltextrestricted-
item.fulltextWith Fulltext-
Appears in Collections:MAE Student Reports (FYP/IA/PA/PI)
Files in This Item:
File Description SizeFormat 
FYP (B185) Final report 2021-2022.pdf
  Restricted Access
2.84 MBAdobe PDFView/Open

Page view(s)

15
Updated on Jun 26, 2022

Download(s)

1
Updated on Jun 26, 2022

Google ScholarTM

Check

Items in DR-NTU are protected by copyright, with all rights reserved, unless otherwise indicated.