Please use this identifier to cite or link to this item:
Title: Fabrication of multilayer microfluidic chip
Authors: Goh, Jun Hui.
Keywords: DRNTU::Engineering::Electrical and electronic engineering::Integrated circuits
Issue Date: 2010
Abstract: This report describes a fabrication technique for building three-dimensional (3-D) microchannels in polydimethylsiloxane (PDMS). A novel system for aligning and bonding of patterned polydimethylsiloxane (PDMS) layers for the fabrication of three-dimensional microfluidic channels is presented. Soft lithography is used for fabrication of the silicon master. PDMS stamps were prepared out of this master and holes were punched for fluidic inlets and outlets. The upper part of the device is micro channel for the fluidic flow and the lower part is of reservoir for trapped the micro beads. Simulation was done by using simulation software, COMSOL for determined the deep of the reservoir required to demosttrate beads trapping. Particles were trapped bycontroling the flow rate and the deep of the reservoir. Alignment of two layers PDMS was performed using Karl Suss Mask Aligner equipped with specific tool designed and created by writer. Microbeads can be individually manipulated and trapped within the reservoir hosted by the device.
Rights: Nanyang Technological University
Fulltext Permission: restricted
Fulltext Availability: With Fulltext
Appears in Collections:EEE Student Reports (FYP/IA/PA/PI)

Files in This Item:
File Description SizeFormat 
  Restricted Access
2.19 MBAdobe PDFView/Open

Page view(s)

Updated on Jan 26, 2021


Updated on Jan 26, 2021

Google ScholarTM


Items in DR-NTU are protected by copyright, with all rights reserved, unless otherwise indicated.