Please use this identifier to cite or link to this item: https://hdl.handle.net/10356/78816
Title: High pressure coolant on hard turning processes
Authors: Seow, Zhi Xian
Keywords: DRNTU::Engineering::Materials::Mechanical strength of materials
Issue Date: 2019
Abstract: Inconel 625 was machined with a PVD coated (Ti,Al)N+(Al,Cr)2O3 carbide tool at speeds up to 60 m/min using varied coolant pressures, up to 7 MPa with and without a tail stock. The cutting forces, surface roughness (Ra) and tool wear were recorded and analysed. The results show that machining Inconel 625 with a high pressure coolant supply increases the cutting force components compared to dry machining. This can be attributed to the ability of the nickel-based alloy to strain harden under thermo-mechanical loading conditions. Vibrations during the machining process can result in up to 30% reduction in surface quality. Cutting forces generated when Inconel 625 was machined with high pressure, with a tail stock, are lower than when machined without. The tools machined with high pressure coolant has a higher failure rate at a higher coolant pressure. The higher the feed, the greater the observed tool wear. Built up edge was the dominant kind of tool wear in the dry machining operation. This could be due to the lack of lubricity provided by the coolant.
URI: http://hdl.handle.net/10356/78816
Rights: Nanyang Technological University
Fulltext Permission: restricted
Fulltext Availability: With Fulltext
Appears in Collections:MAE Student Reports (FYP/IA/PA/PI)

Files in This Item:
File Description SizeFormat 
FYP FINAL SUBMISSION.pdf
  Restricted Access
Main Article51.58 MBAdobe PDFView/Open

Page view(s) 50

111
checked on Oct 19, 2020

Download(s) 50

26
checked on Oct 19, 2020

Google ScholarTM

Check

Items in DR-NTU are protected by copyright, with all rights reserved, unless otherwise indicated.