Please use this identifier to cite or link to this item:
|Title:||Preparation and characterization of nano-sized hydroxyapatite powders produced in a radio frequency (rf) thermal plasma||Authors:||Gu, Y. W.
Khor, Khiam Aik
|Keywords:||DRNTU::Engineering::Materials||Issue Date:||2004||Source:||Xu, J., Khor, K. A., Dong, Z. L., Gu, Y. W., Kumar, R., & Cheang, P. (2004). Preparation and Characterization of Nano-sized Hydroxyapatite Powders Produces in a Radio Frequency (rf) Thermal Plasma. Materials Science and Engineering A, 374, 101-108.||Series/Report no.:||Materials science and engineering A||Abstract:||Nano-sized hydroxyapatite (HA) powders were successfully produced in radio frequency (rf) induction plasma. Fine spray dried (SD) HA powders (average size ∼15 μm) were employed as feedstock. The microstructure, phase composition and thermal stability of SDHA feedstock and the nano-sized HA powders were investigated using scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffractometry (XRD), and differential scanning calorimetry (DSC). Decomposition of powders into other calcium phosphate phases occurred in the high temperature plasma flame. XRD results indicated that an increase in the working power level from 15 to 21 kW led to different trends for SDHA decomposition in the rf plasma flame. At 21 kW, the extreme rf plasma temperature was dominantly responsible for the decomposition of SDHA in the flame. The decomposition at the working plate power of 15 kW was attributed mainly to the relatively lower velocity of the plasma flame. The moderate decomposition of HA feedstock was obtained at a working power level of 20 kW due to mitigating conditions through combined influence of moderate flame temperature and flame velocity. DSC results indicated that amorphous phase content has a positive relation with the recrystallization enthalpy of phase transformation in the nano-sized powders.||URI:||https://hdl.handle.net/10356/95567
|DOI:||10.1016/j.msea.2003.12.040||Rights:||© 2004 Elsevier. This is the author created version of a work that has been peer reviewed and accepted for publication by Materials Science and Engineering A, Elsevier. It incorporates referee’s comments but changes resulting from the publishing process, such as copyediting, structural formatting, may not be reflected in this document. The published version is available at: [DOI: http://dx.doi.org/10.1016/j.msea.2003.12.040 ]||Fulltext Permission:||open||Fulltext Availability:||With Fulltext|
|Appears in Collections:||MAE Journal Articles|
MSE Journal Articles
Items in DR-NTU are protected by copyright, with all rights reserved, unless otherwise indicated.